Eurorack Cable Clips

I have a habit of using long cables that I route off the side of the case and then back in so I can bundle them up in the gaps between rows. When I was just using my single case laying flat, the cables would just stay there, but I recently added a second 7U case that stands vertically, and now all the cables drop down across everything. I didn't find any other designs that suited my needs  so I made my own.

There's one design with the mounting hole offset and there's another with the hole in the centre of the clip. I found that I needed both to fit with different combinations of modules. I use Befaco Knurlies and the thumb screws from After Later Audio without issue, though they probably only leave about 2mm of thread so you may want to step up to an 8mm long bolt to retain the original amount of thread that holds to the rail. Also worth noting is that I'm using Intellijel cases with 3mm mounting hardware. I'd wager 2.5mm stuff will still work, but I have none to test with.

I printed mine on my MK3 with the 0.2mm layer quality preset in PLA.