QIDI Plus 4 Lid Support
This remix trims the top part of the hinge from about 43mm wide to 40mm wide to fit my new Plus 4's handle.
9
79
0
521
updated
March 15, 2025
Description
PDFPrinted on QIDI Plus 4 with Generic PLA settings in QIDI Studio.
Model origin
The author remixed this model.
Differences of the remix compared to the original
I just received my new QIDI Plus 4 (3/14/2025) and when I printed the original model I found that the top part of the hinge would not insert as shown in the handle. I suspect that is because the handle is beveled on the inside face of the handle risers. The opening measures about 40mm on my QIDI on the front side of the handle opening. The original is 43mm wide. So I just “cut” 1.5 mm out of each of the two “wings” of the top part of the hinge that fits into the handle opening so that it would fit my PLUS 4. I'm guessing they MAY have changed the handle design a bit from earlier models. Otherwise the part is identical.
