Flexible Shamrock Keychain

Easy to print, no supports ✅

4mm hole for keychain 🗝

For the best results, use matte filament 🔥 (or better yet, two-tone matte filament like mine). If you look closely at the clover leaf, you'll notice that the layer lines are not parallel but instead converge toward the center, forming a natural pattern. A layer height of 0.2 or 0.24 mm works perfectly for this design.

Don't forget to give me a like 
Share photos of your prints ☘

Personal use only⚠
👉 Check My Patreon 👈
your support is important to me 🫶

Sometimes it's hard to find a flexible four-leaf clover, but believe me, it exists too 🍀🤫