Vitalii3D CNC X Carriage Beacon adapter for Dragon UHF

I bought this cnc x carriage https://www.etsy.com/listing/1639526932/super-lightweight-carriage-for-voron because the dragon uhf made my plastic x carriage heat sets fall out due to the plastic mount softening up from the heat.

I also used this x end stop mount (I use switches) https://www.printables.com/model/768041-extended-x-endstop-for-vitalii3d-super-lightweight.

I chamfered the bottom edges to try to make enough clearance for the end stop mount however it's still a tight fit IMO due to the very bottom section on the end stop mount that hugs the walls of the x carriage adapter. 

With that being said, everything fits together perfectly, however you will want to assemble the probe adapter first and then the end stop mount in that order. I found it was easier that way.

To install the Beacon adapter, you will need 2x 25mm screws.

The adapter dimensions are: 40.5mm (L) x 15.45mm (W) x 18.15mm (H).

This put the bottom of my probe about 3mm above the tip of the nozzle.

The model will import into your slicer upside down for easy slicing. 

Offsets for Beacon config:
x offset = 0mm
y offset = -16mm