12-Cue Firework Ignition Module Case

This is a project created to combine 3 4-Cue BILUSOCN Firework Initiator modules into a single unit. These modules take 4 AA batteries each so I decided to condense the ones I had and convert them to use 2 18650 batteries. In terms of hardware, I only needed to obtain an antenna connector, antenna, and a power switch. The rest of the hardware (screws, battery terminals) came from the original modules.

The antenna connector is held in the the small slot by super glue. This solution is more permanent than I would like, but you could easily be plastic welded in the slot for a more reversable solution.

The pictures of the finished project were put together using 18ga automotive wire, but future modules will utilize 20ga as I think it would be a bit more manageable to put multiple wires on a single connection.

I am currently using the Crackle Cube to interface with the initiator modules. I have tested and successfully ignited multiple firewire igniters at 415ft using this system.

I also use these modules for launching my model rockets.

THE LINKS BELOW ARE AFFILIATE LINKS
(Don't feel the need to use them if you don't want to)

BATTERIES – https://amzn.to/3R8UVp1

ANTENNA WIRE – https://amzn.to/3DIqPWk

ANTENNA – https://amzn.to/4krhCSR

POWER SWITCH – https://amzn.to/4i4jvU7