Batman and Robin Bag Clips

Just squeeze the folded bag top until it is relatively thin and effortlessly slide the clip over the fold.

The color change layers used for the print in the photos are in the provided files.

The batman bag clip shown in the photos used:

1. Matterhackers Silky Silver PLA (batman's suit also had blue or maybe black)
2. Prusa Pineapple Yellow PLA
3. Matterhackers Black PLA

The robin bag clip shown in the photos used:

1. Matterhackers Silky Red PLA (robin's suit also had green)
2. Matterhackers Black PLA
3. Prusa Pineapple Yellow PLA

**Please see the written note below on the licensing of this remixed model.

Replaced the octopus face with the Batman logo and the Robin logo, respectively.

The robin logo was obtained here:

https://www.printables.com/model/218591-robin-logo-emblem-badge-symbol

However, I did not list it as a re-mix model in the form field above since there is some conflict on the form when combining the three models licensing and it wouldn't let me make a license selection to submit the form.  However, all of the original models allow remixes.

Regardless of the licensing file on this listing, the robin logo model does not allow:

Commercial Use

Free Cultural Works

Meets Open Definition