WLED case for ESP32 and Voltage regulation board

Build a simple WLED setup and wanted a way to enclose the ESP32 board with enough space underneath for the pins and since I went for a 24V system there needed to be a space for a common DC-DC buck converter.

For me this whole setup worked perfectly without the level shifter and only a resistor, so there is no space included for the level shifter.

Component spaces:

• ESP32
• DC DC buck converter
• 3-way 4mm² WAGO for +24V
• 5-way 4mm² WAGO for ground
• 100W Brimeti LED driver power supply

2 x M3 heat set insert nuts and 2 x countersunk head screws are required for the lid. Components are just stuck on some pins because I didn't want to bother with inserts for those. Hot glue does work fine.

I've printed mine in pla for now, if it gets to warm, I might switch it out. But mostly it doesn't.