Wall wart ID and wire wrap helper

Options for voltage identification: 3, 4, 5, 7.5, 8, 9, 10, 12, 15, 18, 19, 24, 48, 52

…or… AC, DC …or… BLANK

You can also print in different colors to identify different adapters

All .stl are now revision 2, which makes it fit even if there is a ground prong

Your choice to wedge the bare wires in-between the clamp or insert the barrel jack

Try wrapping different directions or over-wrapping the wire to end up with just the right length at the end.

Designed to hug the prongs securely, squeeze the barrel jack to prevent slipping out, and protect the prongs from entanglement with other adapters when thrown in a bin.

Suggest using PETG (only a 16min. print on 0.15mm setting, no supports, I don't need a brim)

Need a "Type C plug" version, commonly used in Europe, South America & Asia?
This guy made it: https://www.prusaprinters.org/prints/124355-wire-cap-for-europlug