.277 Wolverine, Pocket Snap Latch Modular Ammo Box

This will be superseded by a similar model in the https://www.printables.com/@brass_ring/collections/2345627 collection.

The Snap Latch snaps into a locked state when it is pressed towards the box front and it passes over a retaining tab. To open the box, pull the latch past the retaining tab and lift the box's lid.

Look in my Ammo Boxes Collection https://www.printables.com/social/261776-brass_ring/collections/167118 to see my ammo boxes with different latches and hinges options.

Other ammo boxes of this type can be found in my Single Snap Latch Ammo Boxes Collection https://www.printables.com/social/261776-brass_ring/collections/491054.

These cartridge boxes are printed as separate parts that are printed in orientations chosen to maximize strength and then snapped together.

The box halves require moderate infill (10%-20%) and can be printed with no supports, but I prefer to paint on supports under the flat sections on the hinge hoops, the latch brackets, and the latch catch. I printed with 0.20 layer height in PETG and PLA.

Assembly instructions:  See the attached PDFs

Category: Tool Holders & Boxes