SMK CP1/CP2 Target Grip

A target pistol grip for the SMK CP1/CP2 air pistol.  

It JUST fits on the bed of my Prusa Mini, although it did take me a few attempts to position it just right in the slicer so as not to get a toolpath error.  Both parts can fit on the bed and print together.  Theoretically should fit on anything with a 180x180x180mm build volume.

Uses the original trigger guard mounting bolt to attach the grip to the pistol valve tube.  Needs two M6x35mm bolts and two M6 nuts to attach the adjustable palm shelf.  The M4 screw from the rear of the original handle is not used with this grip.

v2 now added.  Fixed a couple of issues with internal parts poking out through the surface of the grip and generally tidied up the design.  Removed some unnecessary internal geometry to decrease print time and material usage.  New version now more suited to printing upside down to reduce supports.  The old version also left some un-removable supports inside the print, so this has been rectified.  Seperated out the Palm Shelf and Grip to individual models to allow you to place them how you want on the print bed.

Picatinny rail section of grip removed to allow printing on smaller printers like the Prusa Mini.  I also reduced the polygon count a bit from the original STL file, as Tinkercad was getting upset and screwing up the geometry while editing the file.