This modern train platform in H0 scale consists of four parts: platform, two roof supports and the roof. Put multiple platforms in a row to create large station areas.
The supports are 50 mm high which should be sufficient for most trains. But at that height you need to stay clear of curves or turnouts as carriages might hit a support beam when not moving in a straight line. If necessary, the height for the supports can easily be adjusted in PrusaSlicer by scaling the Y axis.
It is a fairly easy print without supports and 15% infill. Make sure you have a clean print sheet, though, as the edges of the platform require good adhesion. The roof can be printed with brim in vase mode which I think looks a bit nicer than the regular print.
I used marble PLA for the platform, grey PLA for the roof supports and transparent PLA for the roof itself.
The author marked this model as their own original creation.
