Tri wick holder for a 110mm jar

The ring is designed to fit over the top of a 110mm glass candle jar, as requested by a member of this website, and provides 3 locations to place and secure wicks located on a set radius from the center and an additional center location in the event a single wick candle was being made. 

The holes for the wicks are slightly oversized to allow slightly frayed and unraveled wick ends to pass through and each hole has built in wick retention via tapered channels off-shooting from the holes.

I am the original creator of the 100mm jar file and was asked by a member on here if it would be possible to modify the file to have it print for a 110mm jar. 

This is that updated file. 

Disclaimer: I do not have a 110mm jar to test this model on however it is designed with the same tolerances as the original so it should work. If it doesn't please send me a message with what the issue is and I will see if I can get it corrected.