Bob the articulated SNAKE ~~~~~[:] NO SUPPORTS NEEDED

Introduction:

Let me introduce you to Bob, a cube-shaped snake with adorable little eyes. Its articulated design allows each segment to move within a 90-degree range. Bob comes in two different lengths to fit your print bed size, and you can customize his length using the provided F3D file.

If you don't have a multi-color printer, Bob will come without his eyes. To give him a happy life, please print the "1 set of eyes for Bob" and attach them later :) For those with a multi-color printer who want to print him as a single piece, use the F3D file.

Printing instructions: 

Print Bob lying on his side (watch included support on one side)!

Optimal print settings for Elegoo Neptune 4/Pro/Plus/Max:

• Printing speed: 250mm/s
• Supports: NO
• Layer height: 0.2mm
• Wall thickness: 0.84mm
• Infill: 10-100% (as you prefer, heavier or lighter)

Any questions or suggestions? Don’t hesitate to reach out—just send me a message on Printables! 😊

I would love to see your makes!

HAPPY PRINTING!