Recessed Battop for Sanwa JLF Joystick

Introduction

This is a battop for Sanwa JLF with a 17.2mm recession.  When installed on the normal JLF shaft, it simulates installing the battop on a short shaft.  As a balltop enjoyer, I really like this configuration a lot.

This is an idea inspired by folks on the /r/fightsticks Discord.

Future Changes

• None

Printing Suggestions

• 4 Walls / 40% Cubic Infill / No Supports
• 0.1 Layer Height for more detail on the rounded top
• Only tested in PLA/PLA+, but other materials should work.
• Recommend enabling polyholes in Orca Slicer – or equivalent
• I like it with fuzzy skin set to 0.2/0.2
• You may need to make adjustments based on the tolerances of your printer

Assembly

Remove your current balltop and shaft cover.  Install the shaft cover with a smaller diameter hole and install this battop. Profit.

Happy Printing!

RAF