Extension Lead (Power Bar) Desk Mount

UK extension leads are quite wide and have plugs with cables that go off to the side, which makes vertically mounting a powerbar rather inefficient. This is a mount that holds the powerbar the way wall sockets are using the screw holes on the back, and allowing you to easily remove and replace the powerbar as required

Requires:

• 1x M4 bolt (>10mm length but anything longer will do)
• M4 nut (I used Nylock but any will do). 
• 2x cable ties (<6mm width, long enough to go around whatever you're mounting this to
  • Alternatively use velcro/double sided tape

You'll need to print 2 of these (one for each screw hole). Requires a small amount of grid supports on the bed for the cable tie gaps