rigid wall mount for navimow GPS module

This is a wall mount for navimow GPS. You need the upper portion of the original pole. 
Of course you can use it for any other pole with 25mm diameter.

Additional you need 2 M5x35 screws and M5 nuts. 

This mount is in 2 parts so you have best strength in regards to the layer lines.

Print/assembly instructions

• use PETg, ASA or ABS
• print in given orientation for best strength
• 3 perimeters
• 15% cubic infill or more
• put mounting plate over the arm
  • if parts are to tight you need to sand the inner part of the mounting plate
• optionally glue both parts together (I printed in ASA and therefore I uses Aceton to weld both parts together)
• put nuts and screws, don't tighten them yet
• use countersunk screws to mount it to the wall
• put upper part of the original pole in zhe mounting arm, adjust the height and tighten the screws

Additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes.
If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.