Mountain Coffee filter holder

If you print the largest size, it makes an awesome paper plate holder!

Went with the gang and did the 100mm at 127% for Hario V60 02 filters. What a lovely model! It looks just grand. Thank you, kind designer! (edited)

Printed in PETG and scaled 127%, as suggested by another user, for use with Hario V60 02 filters.

Very nice model - great addition to my coffe station :)

For V60-02 filters, I printed "side 120mm"

I like it. Perhaps I’ll re-print it later since it has too much space for filters if I scale it proportionally (my filters are 130mm).

Turned out great, had to reprint because I made the same sizing mistake (before the files were renamed).

For people with Hario V60 (02 size), you'll probably want ~125ish mm length. The 120 will fit, but the illusion of snowy peaks is not as good because the white is exposed in the "dirt" section.

Thanks for making and sharing this design! Printed 100mm variant scaled to 127% for the Hario filters. Printed with Prusament PETG via 0.6mm nozzle.

It is an appealing design for sure. I tried to follow the measurement guide on the Details tab but it doesn't feel like my Melitta #4 fit very well. I do like how sturdy it feels. I too with with fuzzy walls and embossed text.

Nice mountain!

I'm sorry but I find the naming of the different sizes to still be very confusing. Why do the filter sizes not match any of the print files? Do you need to print the holder slightly larger or smaller than the filters? And why is the smallest one so large? I have V60 01 for 1-2 cups and none of the measurements I took of my filters seem to match any of the print sizes, nor the filter sizes on the details page. The filter I have measures 106mm on the side and 145mm from the upper outside corner to upper outside corner. I'm not sure which file I should choose for my filters (edited)