Glue Dispenser for Würth MAK38 MethylMethacrylate glue

Very strong and expensive glue. But to use them you need even pricier dispenser so I designed a little jig, to push the glue out from both tubes close to exactly same amount Part A and Part B

You dont necessarily need mixing tip, just squeeze it in a small container and mix very well (when you think youre done, mix it some more)

Print Settings

Best to use PLA due to low shrinking koeficient.

Pistons are quite a tight fit so you dont squeeze too much from one tube.

My settings were:

PLA

3 perimeters

15% gyroid infill

But it is material and settings independent. 

Prints without supports