Induction Coil/Heater Sterilizer (No Soldering required)

Remix of Myco Dogs model. I changed it up a bit to better suit what I wanted. Parts and affiliate links can be found on the original model. 

Print with both flat sides down with no supports. I used 15% infill with PLA+, but any filament should work fine. 

I've included three variants of the base and lid models. Solder, No solder, and a hybrid. The hybrid will work with either the solder or the screw-in terminals. Then each of the lid models have an option for a button or without a button.  

You will need:

• Induction heater
• 5.5 x 2.1 Jack Plug
• 12v 5A/10A power supply (10A preferred)
• Either a foot switch or push button
• Four 12mm M3 bolts (Optionally, you can use the heater to heat a piece of metal and plastic weld the two halves together, which is what I did as a temporary solution)

List of changes from original model:

• Removed text from the case
• Made three different variants
• Changed the hole(s) for the coil so that you can use the screw fasteners, which means no soldering required

• Removed text from the case
• Made three different variants
• Changed the hole(s) for the coil so that you can use the screw fasteners, which means no soldering required