Banana Pi Case

Hi folks,
this pi case is untested, because I have no 3D printer yet.
So feel free to test the case. Perhaps you can give me some feedback.
There is one fault, that Iam not able to fix. It's a bug with the LCD display cable vent. I can't get the "ghost"-vertices away. But I think I can cut it out with a cutter knife later on. If somebody could gave me a piece of advice I would be very hapy too!

Print instructions

Category: Electronics Instructions

I build it with blender and took http://www.thingiverse.com/thing:427848 for masurements.

Thank you very much ghfame (http://www.thingiverse.com/ghfame/about) for sharing your model of the pi!!!!