Limelight 3A case

!!! THIS CASE IS DESIGN TO BE USE OFF THE ROBOT FOR PROGRAMMING PRACTICE ONLY !!!

Due to heat dissipation concern, we only tested the limelight 3A casing off the robot during programming practice only since the case hinder the ventilation of the limelight 3A.

During our practice programming for the next year of FTC, we purchased the limelight 3A and notice the camera bump of the design. As the camera is being transfer around the team, there is a concern about the safety of the lens and thus resulting in this design casing.

BOM:

2x 3x4x5 m3 heat insert

2x m3x14 BHC screws (SHC is also fine)

Printing:

• Support: No
• Infill: 40% adaptive cubic
• Wall: 4
• Top: 3
• Bottom: 3

Designed by: KMUTNB GEARS 22999