Heewing T1 Rear Hatch for DJI O3

• upper part is compatible with my mounts for atomrc swordfish and volantex phoenix 2000 v2
• 8(!) 5x5x(≤5) magnets needed, they should be as strong as possible
• press magnets inside pockets (mind correct polarity for assembly)
• clip antenna into place
• the antenna cable can be a little bit in the way when closing front hatch before flight, gently push it aside
• due to printing orientation and this being a 2-wall-print, the magnetic force isnt as strong as one would wish, but enough for flight so far
• I attached the project file for orcaslicer that I used with my creality k1c
• print in sufficiently heat resistant material
• supports needed, be careful when removing, make sure they dont block the pockets for the magnets
• advantages: modularity, simple to use
  
  thx to @aviphysics (thingiverse) for the original model of the blank rear hatch

blank to o3 conversion