Cryptex

A cryptex with a five-digit customizable code, just like in the movie. To assemble the model/ set your code you must:

1. take one “spacer (print 5 times)” and slide it all the way down the “outside cylinder”
2. align the small slot on the inside of the first "Keyring (print 5 times)" with the slit in the “outside cylinder”
3. slide one “codering (print 5 times)” over the first keyring, so that the first letter of your desired password (e.g. the “A” from “Apple”) lines up with the arrow on the side of the outside cylinder.
4. slide another “spacer (print 5 times)” over the code-and keyring pieces.
5. repeat this process 5 times, so that you now have a custom 5 digit code. For the very last spacer at the open end of the “ outside cylinder”, use the “big end spacer”.
6. glue the “big end spacer” to the “Outside cylinder”, but be careful not to glue the spacer to any of the rotating coderings, otherwise the cryptex will not work.
7. with all the little slots in the keyrings lined up with the slit in the “Outside cylinder”, push the “inside cylinder” into the “outside  cylinder”. It should be able to freely move back and forth, so that you can open and close your cryptex.
8. scramble the code and make sure you cant open the cryptex anymore.
9. optional: print out the availible display stand and display your new safe on it.