Watertank fitting with JSN-SR04T level sensor & optional Pump Power Cable Cutout

This is a 3D-printable adapter designed for water tanks with a 2-inch buttress thread. The design features:

• A hole to accommodate the JSN-SR04T ultrasonic sensor for water level measurement.
• A passthrough for a 30mm water hose
• A passthrough for a power cable, for powering a submersible pump 
• A tight-fitting cap to ensure a secure and splash-resistant seal.

This adapter is perfect for integrating smart water level monitoring and pump control into your setup while maintaining a clean and functional installation.

Print recommendations:

• Material: PETG or ABS for outdoor/water-resistant applications.
• Layer height: 0.2mm for a good balance between strength and detail.
• Infill: 40% or higher for durability.
• Supports: Minimal supports may be required for overhangs.