Sexy peach

It could be a peach... or it could be asuper sexy juicy peach to be used as agift box.

After the printing you need to assemble the two peach parts using the hooks. They need to be stuck in the holes (fig 2). Don't forget to put the stalk in the correct location before closing the peach.

If you print also the panties for the assembly it could be easier tu put earlier the panties in the stalk (fig. 2.s) and after close the peach. In this version you can use the leaf as base for standing the juicy sexy peach (fig. 3.s).

Enjoy.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.2

Filament: Doesn't Matter PLA, PETG

Notes:

I printed it in PETG without supports. Anyway using supports or not depends on your printer quality.

Because of the dimensions it could be a little bit challenging printing the hooks if adhesion to the plate isn't perfect.

I'm sure with PLA you will not have any problem.

Post-Printing

You may need sanding a little bit the hooks (and panties).

Category: Containers