LED light bar bracket for the Ender 3v3 PLUS, for use with the Creality LED light bar. Includes a place for the switch that comes from Creality, along with a hidden tunnel for the wiring. You will likely have to extend the wires, as my Creality kit didn't even provide enough wire for the “factory” location. Includes a mount to relocate the filament runout sensor.
Print with supports. I used the support painter and only painted the spots that really needed it. I did not support the wiring tunnel, which it will do if you do auto supports. It will still work, but I was afraid it may be hard to get the supports out of the tunnel because they are kind of hidden.
Print laying on the side, as seen in the picture.
I printed with ABS, using 0.12mm layer height.
The author marked this model as their own original creation.