Simsonn Handbrake Cable Extension Box

I use a Simruito type handbrake with Simsonn Controller . The Simruito factory controller was faulty, the connection pins are the same as the Simsonn pedals. I made an extension box with a 3D printer, because the Simsonn control box is under the pedals, and I made 1.5 meter cable with crimped RJ9 4P4C plugs at one end or you can buy one at the link provided. You can reuse pins from another connector (RJ11 also works).  You need to fold the 4 pin connector into the printed RJ9 connector. You need to solder the wires of flat telephone cable to the rj9 pins in the box. It is recommended to use heat shrinkable tube!

Need: 

- 4 pcs M3 x 9mm screw

- Telephone Socket on the Wall 1xRJ11 https://www.amazon.de/-/en/PremiumCord-Telephone-socket-self-adhesive-trz4/dp/B07TKM82JM

- COMNEN RJ9 -RJ9 Telephone Data Cable 4P4C Male to Male Modular Data Cord Handset Voice Extension Data Cable 1.5 m

• Supports:

         Yes

• Resolution:

         RJ9 connector 0.08 mm, Box and Top Cover: 0.20 mm 

• Infill:

         RJ9 connector: 30%, Box and Top Cover: 15% 

• Filament material:

         PLA