Double frame for Elko and Aqara Opple

The frame does the job to add a spot for aqara opple below an existing switch. I guess the design is not 100% perfect, but it does the trick for me at least.

Print instructions

0.15mm structural

0,40mm nozzle

15% infill

Supports: recommended

Brim: recommended

Tip

Glue some 3mm thick magnets in the aqara room.

The magnets can be “hidden” by using a permanent marker with same color as your print.

I combined these two models, took the Elko part from one, and Aqara from the other. I also did some customizations.

https://www.printables.com/model/393240-merten-m-smart-double-frame-for-merten-and-aqara-o 

https://www.thingiverse.com/thing:6585907