Next Level Racing Racer GT - cable holders

Do you have a kid, dog, hamster AND/OR wife and want to get rid of cables around cockpit? If you move the rig you need it specially and HERE IT IS :).

Seriously I just do not want to have “spagetti monster around” as I move it 3meters up and back in living room 

NAMING

• Upper = the one I have at top and only difference is it is longer, to hold more cables
• Lower = the one I have at bottom and holds few cables

Feel free to print twice UPPER/LOWER, there will be no problem

PRINT

• PLA - prusament settings (215°C/60°C)
• 100% infill
• Print on side as on second picture

USAGE

1. Print it
2. Stick double side tape on the part with (hook) at the bottom
3. Place from the “hook” side to the “GT Racer” plate
   1. The shorter goes in my case at bottom as at top I have more cables and I need at top more room than at bottom. If you have massive spagetti monster feel free to print both big and vice versa.
4. Stick the bottom part

As it hold mainly on the plate of cockpit it should be firm enough to hold all cables ok.

Feel free to remix, but do strictly not sell.