Small Parts Storage Tray

Printing is fairly straight forward without any restrictions or fancy settings. I used Creality Hyper PLA filament on my Creality K1 with just the defaults settings except with 3 wall Loops or perimeters.

The box and part bins were purchased from Amazon as shown below. The box will hold 2 trays totaling 6 bins.

I started out playing around with the Gridfinity design, but I found buying the storage boxes a better solution. So, all I needed to Make was the storage tray and then a solution for storing them which also resulted in buying a box.

4 Pack Rectangular Clear Plastic Storage Containers Box with Hinged Lid for Beads and Other Small Craft Items (8 x 4.7 x 2.3 inch)
https://www.amazon.com/dp/B0CYWTD5MP?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

36 Pieces Small Clear Plastic Beads Storage Containers Box with Hinged Lid, Storage Case of Small Items, Crafts, Jewelry, Hardware (2.12 x 2.12 x 0.79 Inches)
https://www.amazon.com/dp/B08PL22ZTB?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_20&th=1

Printer:  Creality K1
Slicer:  Creality Print v6.0.3.1591
Filament:  Creality Hyper PLA
Print time:  50m 53s
Filament Length:  10.46m
Layer Height:  0.20mm
Nozzle:  0.4mm
Wall Loops:  3

CAD:  TurboCAD Platinum 2020