Powerbank Connector Panel

This is a panel for my 4s1p lifepo4 “portable powerbank” with 314ah.

The panel is around 29cm long(like the batteries), 3cm wide and 3cm deep. I incuded a small lid of 2mm around the top. The upper wall( with the connetors) is 1cm strong. The conectors fit very tight but some glue is advised. There are two cut outs on each side for the cables coming from the battery poles. 

It features one connector for the charger, one for xt60, three for 65w usb-c charger and one xlr.

The usb-c chargers are 2cm wide and i found them on aliexpress.

Settings:

I printed it in petg, 0.3mm draft and 5% adaptive cubic infill.

Of course, i also i cut it in two parts ;) 

Printing it in two parts makes it easy to add more connectors if needed without ripping everything out again.