Kickstand for Samsung Galaxy Tab S9, S9 FE, S10 LITE, S10 FE

Taking @fabernex_542538 designs and @BargainBin_1518988 re-design, I modified the newest @fabernex_542538 model (v2) to fit the magnet placement of Samsung Galaxy Tab S9 FE model and 10x2 round magnets. Should work also for Tab S9, S10 FE and S10 LITE.
@BargainBin_1518988's re-design was a bit too unreliable in terms of maintaining tightness after angle adjustment and I wanted something a bit more robust, so @fabernex_542538 newest (v2) model made me want to redesign it for the S9 FE as well.
It's a 3 part print - 1x of each of right, left hinge and kickstand. I was able to print the kickstand placing it diagonally on the build sheet of my Neptune 4 PRO.

BOM

• 1x “S9FE-hinge-left”

• 1x "S9FE-hinge-right"

• 1x “S9FE-kickstand”

• 4x M3x30 bolt 

• 4x M3 nut

• 8x or 16x Magnet d10x2 (I used double magnets in each location for added security)

Assembly (taken from @BargainBin_1518988 description)

1. Take your magnets and place them direct on the back of your tablet. Take a marker and mark the top of the magnets. Polarity is important. Place the magnets on the hinge pieces exactly the same spots as they were on your tablet with marker side up. It is important the magnets don't get mixed up otherwise the hinges will not attach to the back of the tablet. I used super glue to attach the magnets to the hinge pieces. You can probably tape over the magnets as well (Note - for me personally the magnets were press-fit tight without any additional adhesives).

2. Attach the the hinges to the kickstand piece. Make sure the screw holes line up. Put the nut in the receiving position and turn the screw through the holes to connect the pieces and tighten as needed. Do the same for the remaining 3 hole positions.

3. Attach the the kickstand to the back of your tablet. It should magnetically attach with no issue. You may want to adjust the screw tightness to your preference. Here I added additional magnets to each position to improve the magnetic attachment.

Inspired by @fabernex_542538 designs and @BargainBin_1518988 re-design, I modified the newest (v2) model to suit S9 FE model and 10x2 round magnets.