Power Switch for Prusa Enclosure

You can no longer reach the power switch or want to turn on your printer without looking for a switch?
This could be the solution for you!

---------------------------------------ATTENTION!---------------------------------------------------

Knowledge, prior knowledge and the use of electronic installations are both assumed and required. If you are not familiar with this topic, please contact an expert.

                           You do this installation on your enclosure and printer at your own risk!
---------------------------------------------------------------------------------------------------------

Additional components are required:

Electronic components:
1x Switch
1x C14 Male
1x C14 Female
There are also matching cable lugs and cables for connecting electronic components.

Mounting components:
3x Thread Inserts M3
3x Cylinder Head Screws M3x8mm

If you don't have the Basic Board and PSU for Original Prusa Enclosure (for Filtration unit and LED) extension A C13 to C14 power cable is required to connect to the power supply.

Switch	C14 Male	C14 Female

Thread Insrts M3	Cylinder Head Screws                          M3x8mm	C13 to C14 power cable