Quest 3 Zenni Prescription EyeTrackVr Mount

I used PLA with linear supports and a raft.

You may need to heat up the camera mount so you can bend it to make the camera fit.

I First tried making a V1 with different LED mount positions.

After printing this I ended up snapping the camera mount trying to put the camera in. I made it a little more chunky, camera has a hard time getting in now, but it will likely stay if it does.

I changed the LED mounts since the ones on the original model seemed too small, and broke while I was trying to mess with it.

Changed the LED layout as well, I don't know where they should be best, but it fits in the headset.