The pipe, handle, and fins top do not fit upright on a Prusa MKS3+, they have to print sideways. As a result, there is some scoring on the side due to support removal. I printed at 0.3mm, might come out smoother at lower layers but that print would take much longer. Additionally, in the close up tape measure shot you can see where I cut the top with the slicer so it would fit. Otherwise, fantastic print, love the assembled product. Put it on the wall, looks great. Not complicated to make but hooks are here: https://www.printables.com/model/510527-wall-mount-for-tusken-raider-chief-staff
The pipe, handle, and fins top do not fit upright on a Prusa MKS3+, they have to print sideways. As a result, there is some scoring on the side due to support removal. I printed at 0.3mm, might come out smoother at lower layers but that print would take much longer. Additionally, in the close up tape measure shot you can see where I cut the top with the slicer so it would fit. Otherwise, fantastic print, love the assembled product. Put it on the wall, looks great. Not complicated to make but hooks are here: https://www.printables.com/model/510527-wall-mount-for-tusken-raider-chief-staff