Fan support DEYE 6kw inverter

I have created a support for three 92x92x38 mm fans for a Deye 6kW inverter. In summer, the heat increases the temperature, so it is used with a PWM controller that can be purchased on AliExpress, along with the fans and other components. There are four parts to print, with a total printing time of about 3 hours. The largest part measures 186 mm. After printing the two fan supports, insert the connectors. The connectors are designed to be slightly smaller, so scale them if the printer is not well calibrated. The support should fit behind the inverter without the need for additional holes. The controller will adjust the fan speed based on the heat using its temperature probe, and it is fully configurable.