Camera Mount Prusa MK4s / EZVIZ Smart H1c

I printed as follows: 
printer - Prusa MK4s
filament - Generic PLA
setting - 0,15mm SPEED
fill - 50% 

I added a round base to the original model as a subfloor for the above mentioned camera. The metal washer supplied by the camera manufacturer will be glued to this base, to which the camera is then magnetically attached.

I added a round base to the original model as a subfloor for the above mentioned camera. The metal washer supplied by the camera manufacturer will be glued to this base, to which the camera is then magnetically attached.