HP 750W Powersupply cover

Compatible with HP DPS-750RB A Server powersupply.
It will probably work on most HP powersupplies that have built in fans.

Useful for charging lipo batteries or anywhere you need up to 750 watts of 12v power!

To assemble, short the first and forth pads from the left with a switch. The two large pads will then provide ~12.3 volts.

Use a zip tie to secure the large wires to the metal frame to prevent the solder joints from breaking if they get pulled.

Parts

• Rocker Switch I purchased this one from amazon

• Led
  Any 5mm led will work. I used a white led and a 680ohm resistor. Any resistor between 220 and 800ohms should work. If you want to be precise, calculate the required resistor here
  The screw is just a standard hard drive screw. I used a washer since the screw was a little bit too long.

  ### Versions

  2.0 - Redesigned to allow for air flow
  1.0 - Initial design (deleted because would overheat)

Print instructions

Category: R/C Vehicles