Cross Puzzle with soft edges

Cross Puzzle - 3D Printed Model

This Cross Puzzle was printed on an Elegoo Neptune 4 Pro. The print settings were as follows:

• Print in 100%, 75%, or 50% size (choose based on your preference).
• Use 25% infill to add a bit of weight and stability to the puzzle.

For the 75% size, it takes approximately 1 hour and 40 minutes to print everything on a single plate. You will need to print:

• 2 copies of the body
• 4 copies of the pins

Assembly Instructions:

1. To install the pins, start by inserting the side with the hole into one of the body sides.
2. Then, push the other side of the pin into place. You may need a pen or a screwdriver to snap it fully into position, depending on the print size you chose.
3. Repeat this process for the remaining 3 pins.
4. Once assembled, shake the puzzle and challenge your friends to separate the two halves!

Solving the Puzzle:

1. Place the puzzle on a flat surface.
2. Spin it quickly, causing the pins to move toward the outside.
3. Once the pins are positioned, you can lift the puzzle straight up to separate the halves.

Enjoy solving the Cross Puzzle!