P1P/P1S Z-AXIS BEARING DUST CAP

I was looking for a top z-bearing dust cover to fit my P1S and could not find one that fit well. I decided to take some measurements and sketch my own. I wanted something low profile but sat proud so your basic scraper could fit under the edge to pop it off easily. I also wanted a cap with a void on the underside to avoid contact with any rotating components. 

I printed this model using:

*Bambu Studio

*Bambu ABS filament (PLA/PETG/etc will work- I just wanted a higher temp rating)

*Standard presets should be fine (it was personal preference to change Top Surface to “Monotonic Line” and Bottom Surface to “Archimedean Chords”)

With these changes:

Total Filament- 1.32g

Should you find this model helpful, please like and I will start uploading many other new designs! Thanks!