Logitech C270 Camera Magnetic Mount

I originally got this camera mount from another site and remixed to be better and magnetic. You will need one M3 30mm screw and nut for the camera and one M3 20mm screw and nut for the pivot between the two brackets.

I used 6mm x 2mm magnets and they fit perfectly snug inside the print with a little pressure. I did put a drop of super glue inside the holes to help hold them in place as the magnets are very strong and they would pull out when trying to separate.

Print as many wall plates as you need to move the camera around your enclosure.

link to the original https://www.thingiverse.com/thing:3103230

Print instructions

Supports are only needed on the camera bracket.