Anker Prime Charging Station

This charging station is designed around the Anker Prime Charger (250W). 

It has a drawer to store charging cables.

One charging bay accommodates the Anker Prime 27,650mAh Power Bank, and two accommodate the Anker MagGo Power Bank (10k).  

The remaining charging bays accommodate iPhones or iPads.

It was printed on the Core One using Polymaker Panchroma Matte PLA Filament in Matte Muted White.  It was printed at .20 mm SPEED, with 15% Grid Infill.  Snug supports were used on the base for the USB B access hole.  The base should be printed with the back side on the printing plate.

Behind the drawer and behind the charging station, there is a raised portion to prevent them from being inserted too far.

The base is 220mm wide by 160mm deep by 147mm high at the highest point.

The inside dimensions of the drawer are 76.2mm wide by 146.2mm deep by 45.1mm high.

The drawer fit is snug, but with my printer and print settings, it operates smoothly.

12" cables will work to charge an iPad in the furthest slot from the charger.

Thanks to @dandoe_1296214 for your design inspiration!

This model is specifically designed around the Anker Prime Charger (250W). It accommodates the right-side dial button and the right-side USB B ports.