Wago Series 222 compact holder

It is simple. It is compact. It stays in place. It has a very satisfying snap when you mount the connector. It fits all versions of the Wago 222 Series connectors.

Instead of leaving your connectors hanging, print this and tidy up your installation in a snap! It prints in a matter of minutes.

Printed on a Prusa Mk4S using PETG. Default settings with 15% gyroid infill and 0.2mm layer height. Organic supports is required but comes off very easily, so for a small series it is a quick and easy clean up.

I'm aware that there is a tiny gap between the connector and the print, but that is what gives it that extra tension to make sure the connector won't fall out. It is a design feature, not a bug. :)