Tupperware lid holder

My wife was looking for a lid holder for all her lids. i couldn't find one here so i decided to model my own. I iterated it 4 times so far. the Holey version is the latest, it prints the fastest, and uses the least filament.

tinker links if you want to play with the design some
https://www.tinkercad.com/things/j7G3zqEOy3z-copy-of-half-solid-lid-holder
https://www.tinkercad.com/things/i4F4A8DmSw4-copy-of-holey-lid-holder
https://www.tinkercad.com/things/79Ti1WMC9mO-copy-of-solid-lid-holder
https://www.tinkercad.com/things/hSUdITWw0na-copy-of-holey-lid-holder-2

Print instructions

Category: DIY Print Settings

Printer Brand: Wanhao

Printer: Wanhao Duplicator i3 V2

Rafts: No

Supports: No

Resolution: 200

Infill: 20

Notes:

printing the half solid was nerve-wracking for my as that 2 mm x 15 mm tower does not connect until it is way way up in the air. I would probably print either the solid or holey in the future and skip the half. For the smallest lids I'd use a 2.5" gap for the largest lids I used a 3.5"
To print two you will want to use the mirror function in your slicing software to create the second side