This is a quick plate i made that allows you to mount a DJI 03 Air Unit into the TBS Caipi 2 Wing bay. From the bottom you screw in to the dji 03 with the appropriate sized screw ( the original ones are not long enough, i used some left over screws from my apex evo frames.
the holes on the outside are just typical m3 holes, you may need to make the model thicker in order to make them deep enough to screw into, i used some m3 stand offs to screw into and then i epoxied the tops of those and placed this one top to hold it.
In order to cool the 03 im using this print here in TPU https://www.thingiverse.com/thing:4673472/files
this has an opening big enough to fit the 03 through for air and then you just have to either cut the latches out of the original door or buy extra ones from tbs and then glue or epoxy them in and it works like a charm, imo these fit better than the original foam hatch covers.
With the print on standoffs you can get a usb cable connected super easy and its just above the wing surface, you can also get an sd card in there and get it out.
The author marked this model as their own original creation.