Rasberry Pi Zero Case

My spin on this great design - added 3 extra cut outs -

1 for camera ribbon cable

1 for a power connector (2Pin)

1 for a filament sensor (4Pin) [3pin could be used with a mod to the model only used 4 pin as thats that i had]

using JST style connectors used-

Header, Vertical, 2 Way - Jst (japan Solderless Terminals) | CPC

Header, Vertical, 4 Way - Jst (japan Solderless Terminals) | CPC

Connector Housing, 2 Way - Jst (japan Solderless Terminals) | CPC

Connector Housing, 4 Way - Jst (japan Solderless Terminals) | CPC

Crimp Terminal, XH, 28-22AWG - Jst (japan Solderless Terminals) | CPC

and changed the nut holes to fit heat inserts in and widened the screw posts on the lid

and added some extra hight for the connectors to have clearance from the pcb now 30mm M2.5 screws required with 4 M2.5 heat inserts

i added the extra power connector so i can plug in usb ethernet addapter and have it hard wired as the wifis not the best in the location i have it setup

will update this post when fitted with where ive mounted it on my printer

added 3 extra cut outs -

1 for camera ribbon cable

1 for a power connector (2Pin)

1 for a filament sensor (4Pin)

using JST style connectors

and changed the nut holes to fit heat inserts in and with the lid widened the screw posts 

and added some extra hight for the connectors to have clearance from the pcb now 30mm M2.5 screws required with 4 M2.5 heat inserts