TBL Pinball Mod - Folgers Can

I wanted to build a folgers can for my pinball machine so decided to give it a shot and here are the results.  

I originally set off to install on the lower left side below the ball return to try and limit the ball bouncing over that ramp and down the drain line, but not sure where I'm going to put it now.

These follow the original can dimensions fairly well.  This can is 30mm in diameter and around 47mm high.  You can double sided tape down with 10mm (¼") wide tape.  I'm also include the model without the base.  The Gcode has a color change for the lid.  The lid is not removable.

You can print the label I found online (see pdf) which has one around 47mm, 35mm, 30mm and high (depending on your printing) and glue on if you want.  Or add any label.

You can print in PLA or PETG.  I printed with no supports and 0% infill.  I left the vertical shells perimeters at 2 but you can increase for thicker walls if you want.