Auxiliary Monitor Desk Stand

This bracket will support a lightweight auxiliary monitor and is set at precisely 14° off verticle. I use it as an instrument panel monitor in my Flight Sim setup. Aircraft panels are traditionally vertical 0°, 7°, or 14° from vertical. Some gyro instruments need a wedge behind them if they aren’t set up for the panel angle. But I digress. You can print it with or without support. I did one of each, and they seem fine, but it might depend on your filament and printer capability. Put silicone bumpers in the divots on the bottom for a non-slip mount.

The base is 290 mm wide so you will need a printer that can hack that.

PLA, 0.24mm Layers, 3 Walls, 20% GYROID infil.