Silicgel box (about 45g of silica gel)-v1.0

The box can hold approximately 45g of silica gel. 

It has a locking mechanism to prevent the lid from falling off. 

To open, a fingernail or tool is needed to lift and remove the lid.

Very important

slicer setting

I printed with PETG

Wall loops: Set to 3.
Top shell layers: Must be set to 0 layers. 
Bottom shell layers: Must be set to 0 layers. 
Sparse infill density: Set to 30%.
Sparse infill pattern: Cross Hatch or Rectilinear
 

By strictly following these red-boxed settings, you should achieve a successful and accurate print.

2025/02/24

Improved ease of opening the lid