DartZone Venom Pro Fidlock Adapter

This is an adapter bracket to allow use of Fidlock mounting plates using the 60mm spacing and medium Fidlocks. This was built with Worker Nightingale-spec Fidlock plates in mind (as its what my current kit uses), but any flat-backed 60mm mount should work fine. 

Please note this model requires the following parts created by RedCowl in order to mount the bracket to the Venom Pro:
https://www.printables.com/model/964022-dart-zone-venom-pro-picatinny-stock-attachment-poi

For those who do not yet have a Fidlock bracket, I use this one by ArmstrongAcc, on Etsy (they also offer Fidlock magnet mounts for many different holster platforms:
https://www.etsy.com/listing/1266202924/medium-fid-nightingale-bar?

Print Parameters:
(3mf is attached and preconfigured)
4 walls/tops/bottoms
100% gyroid infill
Print with the ‘bar’ portion on the plate, aligned as if it were going on the blaster.
Tree supports not required but may help with some printers.

Hardware required (For this bracket; see relevant listing of your Fidlock mount of choice for fidlock-specific hardware):
-- 4x 3mm brass heat-set inserts (these all go in the ‘mounting arm’ and allow slight adjustment between the different hole spacings) and a soldering iron
--2x 3x6mm machine screw (for attaching your fidlock mount to the bracket)
--2x 3x25mm machine screw (to lock this into the picatinny rail, threads into the plastic, be gentle)

Big thanks to my good friend NothinBlasters for helping polish my bracket design :-D